DWM1001 Dev Board design and firmware adaptation

Hello,

I’m working on a prototype tracking device. I’m looking forward to design a very small board . Basically using DWM1001 dev board, and replacing the accelerometer on board by and IMU.

Is it actually possible ? Is the firmware adaptable for this case ?

It seems the accelerometer LIS2DH12TR is embedded in DWM1001C IC module so you can’t take it off.

I don’t think that’s possible.

If you need something like a guide when creating your tracking device, you can check this out: GPS Tracking Device using TTGO - Share Project - PCBWay