DWM1001 update fail

Wireless Connectivity Ultra-Wideband
1

Hi,

I am trying to update a DWM1001 module with J-flash lite 6.14d, but erase failed.
Is the module dead or did I make a mistake? thanks

Erase Thread started.
Device “NRF52832_XXAA” selected.
Found SW-DP with ID 0x2BA01477
Found SW-DP with ID 0x2BA01477
AP-IDR: 0x24770011, Type: AHB-AP
AHB-AP ROM: 0xE00FF000 (Base addr. of first ROM table)
Found Cortex-M4 r0p1, Little endian.
FPUnit: 6 code (BP) slots and 2 literal slots
CoreSight components:
ROMTbl[0] @ E00FF000
ROMTbl[0][0]: E000E000, CID: B105E00D, PID: 000BB00C SCS
ROMTbl[0][1]: E0001000, CID: B105E00D, PID: 003BB002 DWT
ROMTbl[0][2]: E0002000, CID: B105E00D, PID: 002BB003 FPB
ROMTbl[0][3]: E0000000, CID: B105E00D, PID: 003BB001 ITM
ROMTbl[0][4]: E0040000, CID: B105900D, PID: 000BB9A1 TPIU
ROMTbl[0][5]: E0041000, CID: B105900D, PID: 000BB925 ETM
Debugger initialized successfully.
J-Link: Flash download: Total time needed: 0.075s (Prepare: 0.057s, Compare: 0.000s, Erase: 0.017s, Program: 0.000s, Verify: 0.000s, Restore: 0.000s)
Failed to restore target. RAMCode never stops
Erase Thread exited
Erase failed.

2

Hi Xranger

Are you using a devboard with onboard Jlink, or you own design with an external JLink debugger ?

Thanks
Yves

3

Hi Yves,

Thanks for reply. The issue has been solved, I use a Jlink in 4 pin SW mode,
after updating a latest driver, the erase is OK.