I am getting “command not found” when attempting to set PAN ID with “nis.” I used ? to get help and the command is not available. Here is the result of “si.”
Sorry about the NUB posts…I updated the FW on on the gateway DWM1001-DEV and used nis and nmb commands to set the PAN id and bridge mode, respectively. I got the PAN ID from the Android app, it’s the network id I created.
The contents of the RP3 dwm1001.config are pasted below. The problem I have is that when connect to RP3 from Chrome, I expect to see the Anchors and Tags I configured on the same network, but I don’t. I also see two proxies when I expect to see just one.
For the gateway the panId must be set in the config file, please have a look at the gateway quick deployment guide.
If you set it with “nis”, I think there will be conflict between the config file and the command (the panId from the config file will be eventually used)
Hi Yves,
I have the same problem, but when I set the panid to my network, it does not get saved (is there a way to save it?). Instead it creates a separate file sudo nano /etc/dwm1001/dwm1001.config.save
Please help