Hi all,
I am configuring my DW1000 based pcb board to integrate it as a tag in the two way-ranging DecaRanging setup using EVB1000 boards.
Currently, the DecaRanging software has been flashed in in all my EVB1000s, but I am unable to find which operational mode configuration they use. Table 3 of the EVK1000 User Manual lists a bunch of possible modes, but it reports that switches S1-5, S1-6 and S1-7 are used to select these modes, whereas the sticker on switch 1 on my EVB1000 (coming from a TREK1000 kit) tells me that those switches are used to set their tag/anchor ID. Since I successfully used the DecaRanging demo, I assume this info is correct.
So I’d like to know: I configured my EVB1000 switches to Channel 2, at 6.8Mbps. Which PRF, which preamble length and which preamble code do I use in my tag so I can use this tag in two way ranging with the EVB1000 boards?
Thank you so much for your replies!
D