I couldn’t get any response from CLI. Can you help please?
According to the needs below which HEX we need to upload to the DWM1001C module?
What will be the commands in CLI? Can you guide us in your firmware?
What I need is:
One or more DWM1001C (moving tag) showing ranges of other DWM1001C modules (moving anchor) with short addresses in the area as a list.
It can be 1 anchor and 1 tag,10 anchors and 1 tag or 5 anchors and 10 tags (the numbers may change) in the area since they all move.
The idea is stopping a vehicle if there is a person close enough. So it needs to be working inside the building or outside the building without a location calculation.
We have done this by the default firmware but 4 nodes limit make it impossible to continue.
We are planning to calculate the location further by placing tags on the ceiling and make the ceiling devices send the ID and range of the moving devices to the server. It can be then calculated by the server.